Phoenix metermanual

Since these agents are sometimes aggressive it might be advisable to check the effect on sensitive surfaces, like cushioning on non-visible areas. Lode will not take responsibility for discoloration due to these agents.

Wheeled frame for the Angio ergometer with fixation set (separately sold) that makes it very easy to place the ergometer over a patient bed and move it. The wheeled frame  is executed with a part of instrument rail (10 * 25 mm) to conveniently connect an additional wired control unit (separately sold) during transport.

Phoenix meterprice

Note: the wheeled frame is not compatible with former models of our Angio ergometer (9179XX). For a wheeled frame for these ergometers, contact our sales department and ask for part number 917816)

Yes, Due to the fact that the scientific research on the spread of Covid-19 is not yet conclusive Lode recommends to disinfect and clean all Lode products and their accessories (cuffs, heart rate belts, SpO2 sensors, handgrips/rails, touchscreens etc) that are in contact with the patient and or the medical personnel with a standard disinfectant as used in the hospital before and after every patient, with attention and care!

Yes, on the backside of the display there is a potentiometer. To have access to this potentiometer you have to remove the upper part of the control unit by removing the screws on the bottom side of the controlunit. ( see service manual for instructions) now you can access the potentiometer and adjust it according you wishes.

Phoenix meterhow to use

Yes you can. Make sure the chipset used in the converter is from FTDI to have good data acquisition. Not sure what this means? Contact us and we will help you to get the right converter.