RIB RelayRIBU1C

With Stryker's decision to discontinue its line of cast cutters and related vacuums, the company also no longer offers parts or service support for this equipment. So what's next for these "workhorse" machines?

I understand that Stryker is no longer selling cast saws and blades – does RPI have plans to continue part support for both the older 800 series cast and autopsy saws as well as the newer 940 cast saws?

Rib relaywiring diagram

Yes! Not only will we continue selling our parts for these discontinued models, we have expanded our offerings by manufacturing blades for the 940 cast saws. Sold in several different versions, the RPI cast saw blades are long-lasting direct replacements for the Stryker 940 blades. RPI has also recently started selling parts for the model 986 cast vacuum and plans are in place to add additional repair parts for the cast vacuum systems.

RIB Relaycatalog pdf

Have a question for the expert or want to find out more after reading his tips? Fill out the form at the bottom of the page to ask Neil Blagman a question directly.

RIB RelayRIBU1C Wiring Diagram

I’m having problems with the blade guard on the model 940 cast saw – I’m having a hard time removing the shoulder bolt and rethreading it in after I replace the blade and clean the head.

RIB Relay24v Coil

Carremm Controls Ltd. 3535 Laird Road, Unit 17 & 18 Mississauga, Ontario L5L 5Y7 Canada Tel: 905-569-0335 Fax: 905-569-9712 Email: carremm@carremmcontrols.comHours of Operation: br> 8:30 am - 5 pm EST. Monday to FridayTwitter: @CarremmControlsClick Here for our Returns Policy and Authorization form

You should use a light machine or sewing machine oil usually sold in a dropper bottle. When installing a new oil distributor, you will want to wet the felt until uniformly dampened without soaking it. And while you’re in the neighborhood make sure the oil seal and gasket are intact – they will keep the oil from leaking out and will prevent the entry of cast dust.

The case on the Stryker 940 cast saw is held in place by 3 screws, only one is exposed. The remaining 2 screws are located behind the decal surrounding the power switch. You will also need to remove the brush caps and the brushes before you can remove the rear section of the case.

2 PoleRIB Relay

What kind of oil would I use in the head of a Stryker 800 series cast saw? How much should I apply when I’m replacing the oil wick?

Carremm Controls Ltd. 3535 Laird Road, Unit 17 & 18 Mississauga, Ontario L5L 5Y7 Canada Tel: 905-569-0335 Fax: 905-569-9712 Email: carremm@carremmcontrols.comHours of Operation: br> 8:30 am - 5 pm EST. Monday to FridayTwitter: @CarremmControlsClick Here for our Returns Policy and Authorization form

Cast saws generate lots of dust and no matter how well the vacuum systems work, there will always be dust working its way into those threads. One solution you can try is a little bit of penetrating oil on the threads to help flush the dust out. However, if the threads are damaged, replacing the output drive assembly is an easy single part fix.

Ask an expert directly! - MedWrench recently contacted Neil Blagman, one of the RPI Product Development Engineers, to learn what he thinks is next for the Stryker Cast Cutters. The answer may surprise you. Neil also offers his best Service Tips for the Stryker 940 cast saw.